EasyManua.ls Logo

Bosch AMC2 Series - Page 17

Bosch AMC2 Series
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
AMC2 Modular
Controller
Introduction | en 17
Bosch Access Systems GmbH 2018-09 | AMC2-4W_UL |
NOTICE: In order to avoid an error message caused by an
earlier voltage drop we suggest to replace the battery
every 8 years. Spare part: VARTA CR 2032 PCB.
4 Reset push button - reachable through the casing using a
screwdriver
5 Liquid Crystal Display
6 Push button, available on top of the housing, to select
different display modes
7 Jumper: Equalization of potential between different
systems and earth ground (shield)
8 Jumper: Interface selector RS-485 host connection,
RS-485 two wire or RS-485 four wire (depends on
external wiring). This host interface is not used for UL
installations.
9 Configurable RS-485host interface. This host interface is
not used for UL installations.
10 Docking port for compact flash memory
11 Configurable RS-232 host interface (ribbon cable
connector). This host interface is not used for UL
installations.
12 Configurable 10/100 Mbit/s Ethernet interface.

Related product manuals