Bosch AVENAR panel 2000 - Triggering fire verification; Alarm verification; Starting time to investigate

42 pt-BR | Fire alarm
AVENAR panel 8000 | AVENAR panel 2000 |
AVENAR keypad 8000
2023-08 | 8.0 | F.01U.378.877
Manual do utilizador
Bosch Sicherheitssysteme GmbH
– Rosa Fúcsia: grupos ativamente controlados sem um alarme real, por exemplo, em caso
de exercício de simulação de incêndio
– Verde: os grupos que não estão ativos
– Amarelo: grupos com falha ou desativados, não é possível controlá-los.
10.2 Optical and acoustic signals
– The alarm LED and the evacuation LED light up red
– An internal buzzer sounds; see also Silence internal buzzer, página 42 .
– Depending on the configuration, sounders and/or visual notification appliances (e.g.
sirens, strobes) are activated.
If the transmission device to the fire department is activated, the LED icon lights up red:
10.3 Acknowledging a message
There are two ways to acknowledge messages:
– Select Reconhecer. Only those alarm messages which are visible in the display are
acknowledged.
– Select a message and then press Reconhecer. Only the selected message is
acknowledged.
i
Aviso!
If Ir para Reconhecer is displayed, select this field in order to display the messages that have
not yet been acknowledged.
10.4 Silence internal buzzer
Press the following key to temporarily silence the internal buzzer:
The internal signal tone is silenced.
10.5 Activate and silence signaling devices
Sounders and optical signaling devices which have been activated can be switched off.
4 Select Sonoros OFF.
The sounder and/or optical signaling device is switched off.
i
Aviso!
On the next alarm message, all signaling devices that have been switched off are switched
back on automatically.
4 To switch the notification appliance back on, select Sonoros ON.
The signaling devices are switched on again.
10.6 Resetting signaling devices and transmission devices
4 To reset control or transmission devices, select Controlo in the status bar
i
Aviso!
The display automatically changes back to alarm indication after 30 seconds. To return to the
alarm indication before 30 seconds have elapsed, select Incêndio.