Bosch CC 100 M - 4. Softkey RECORD ALL DATA

<§l BOSCH
Flexible Automation
Description Stage 4 Chapter 1
Softl<ey
..... AC.:;, I exchanges the axes of the active simulation plane
Example: Working plane XfY .. active:
Y
x
Softkey
Exchange of the axes referred to the active simulation plane.
Y
CC lOOM
User Manual
Softkeys "LAYOUT 1 I LAYOUT 2" changes the simulation display ("toggle" function). The
active mode is displayed in reverse video mode (see example Page 8).
4. Softkey
This softkey transfers axis values (dimensions or positions of the workpiece) to the control. The
control switches back to the softkey basic level. This sohkey is displayed in reverse video mode in
the basic level.
The softkey is omitted in the case of incorrect entries.
The simulation run must be started from this "level" (key "CYCLE START" on manual panel).
Illustration
z
p
¥t
--
y ----~...- •• /
X _L.
-----
Machine
datum
1-8
z.
Workpiece
y.
x,.
www.DaltonsWadkin.com
www.DaltonsWadkin.com
www.DaltonsWadkin.com