Bosch CC 100 M - Simulation sequence

§ BOSCH
Flexible Automation
Current
1001 pos~ion
(XIV)
A
Description Stage 4 Chapter 1
Simulation sequence:
RECORD
CC lOOM
User Manual
After the parameters have been transferred with softkey I ALL DATA I I simulation starts
with key 'Cycle start· in 2 112·0 graphics (in this case: working plane XY top view).
illustration:
__ Iona
Foodrate G1 RapId traverse GO
in Z
'--------
-X
w"',."..,.
The window with the corner points A BeD shows:
- the tool in the selected working plane (XY, ZX or YZ)
- the workpiece and the programmed tool path.
The window with corner points C 0 E F shows:
- the tool position referred to the third axis perpendicular 10 the simulation plane
- the workpiece position referred to the third axis.
Tool position:
E
Currenltool
position (Z)
Wor\qlloco datum
InZ
Machine datum
InZ
F
A small square, displayed in reverse video mode, shows the current tool position. The actual tool
position is displayed as an arrow in the display window of the third axis with comer points C 0
E F.
Tool traverse movements:
- Tool rapid traverse movement (GO) as a dashed line
- Tool feed movement (G1, 2, 3, 5) as a continuous line.
1-9
www.DaltonsWadkin.com
www.DaltonsWadkin.com
www.DaltonsWadkin.com