Bosch CC 100 M - Page 32

§ BOSCH
Flexible Automation
Description Stage 4 Chapter 1
Coordinate rotation (G37)
G37 acts on additive NPV (G60, G160) but not on the NPV (G54-59).
CC lOOM
User Mannal
r:iI'" Coordinate rotation G37 does nctact upon G60/G160 if G60/l6D are programmed in the part
program belore G37 X ... Y ... A. ...
... Coordinate rotation G37 acts on GG0I160 il G601160 are programmed in the part program
after G37 X ...
Y ... A ....
d" The axis values of 0001160 are written into the additive NPV table.
Scale lactor change (G3G)
Values of the additive NPV can be subjected to scale factor change. The additive NPV is then
executed with scaled values. If the factor is reset to 1 whilst additive NPV is active, this remains active
with the scaled values. Stored axis values in the additive NPV table are not scaled.
Mirror Image (G3S)
G6D/G160 are executed mirror-imaged if G38 is already active.
The original axis values are stored in the additive NPV table; G38 does not influence the NPV table.
Activate measuring probe (G75)
Programmed axis values with G75 are shifted by additive NPV.
Work area limits (G25, G26)
No effects on the work area limits if G25126 is active before additive NPV G60/160.
Effects on the work area limits if these are programmed in the part program after G60/160.
1 -28
www.DaltonsWadkin.com
www.DaltonsWadkin.com
www.DaltonsWadkin.com