Bosch CC 100 M - Customized cycles; Purpose, function

@> BOSCH
Flexible Automation
Customized cycles
Description Stage 4 Chapter 2
Purpose, function:
CC lOOM
User Manual
The contour and boring cycles and the relatBd graphic menus are storad in the EPROM.
The contour and boring cycles can be deactivatBd with tl:!is function. The free G codes (81-89) are
assigned customized cycles and stored in the RAM. This means that the cycles and graphic menus
can also be edited by the customer at any time.
Selection:
The machine tool builder, in group operating mode INFORMATION, MTB SERVICE, selects
whether contour and boring cycles and graphic menus are fixed or whether they can be replaced
by customized cycles and menus.
Operating sequence
MACHINE
SERVICE
", "MTB
LINES RESET +
STATUS
':SERVICE
SERVICE DELETE
Enter the pasword:
[ ENTER J
TEXT+
INTERNAL MTB
MACHINE PlC/PLC
GRAPHICS
CYCLES'
CYCLES
PARAMETERS SERVICE
CYCLES
IN RAM
The
default setting (ON) is displayed in reverse video mode in the fields of softkeys BORING and
CONTOUR.
Significance:
BORING ON: The menu of the boring cycles is fixed and cannot be replaced.
CONTOUR ON:
The menu of the contour cycles is fixed and cannot be replaced.
The cycles are deactivated by pressing softkey BORING and/or CONTOUR; they can no longer be
called by the user in group operating mode MEMORY [8 . Status "fixed" is cancelled only
with softkey
. The user can now program his own cycles and graphic menus
which are stored in the RAM. Softkey
mode.
2-7
is also displayed in reverse video
www.DaltonsWadkin.com
www.DaltonsWadkin.com
www.DaltonsWadkin.com