Bosch CC 100 M - Page 53

@> BOSCH
Flexible Automation
Description Stage 4 Chapter 2
Creating the cycles and graphic menu. In the RAM
In group operating mode INFORMATION I <ll: I softkays
TEXT+
CC lOOM
User Msoual
MTB l
SERVICE and
GRAPHICS I pennit access to the editing level in which specific cycles can be created for text
files, menus and graphic files.
Availability In group
Graphic menu
operetlng mode. MEMORY
Defined by:
and MACHINE
Menu 1
always
File number 3 in RAM
Menu 2
always File number 4 in RAM
Menu 3 always
File number 5 in RAM
Menu 4
if
BORING ON
Fixed in EPROM
Menu 4
if
BORING OFF File number 40 in RAM
Menu 5
if
CONTOUR ON
Fixed in EPROM
Menu 5
if
CONTOUR OFF File number 41 in RAM
10 display images always
File number 10-19 in RAM
from menu 1
10 display images always
File number 20-29 in RAM
from menu 2
10 display images always
File number 30-39 in RAM
from menu 3
10 display images
if
BORING ON
fixed in EPROM
from menu 4
if BORING OFF
File
number 70-79 in RAM
10 display images
if
CONTOUR ON fixed in EPROM
from menu 5
if CONTOUR OFF
File number 80-89 in RAM
Condition. for editing the file.:
File number 3, 4, 5, 10 - 39 no special conditions
File number 40,
41, 70 - 89 sof1key
is active.
Operation and programming of the graphic display images are identical to handling the user cycles.
The customized cycles can be edited using the cycle editor in group operating mode MEMORY
[2].
The boring cycles are stored under numbers 81 - 89;
the contour cydes are stored under numbers 90 - 99.
2-8
www.DaltonsWadkin.com
www.DaltonsWadkin.com
www.DaltonsWadkin.com