Bosch CM8S User Manual

27
 Body and Hand Position
Position your body and
hands properly to make
cutting easier and safer. Failure to follow all
instructions, identified below by bullet (•)
symbols, may result in serious personal injury.
• Never place hands near cutting area. Keep
hands outside the “No Hands Zone”.
The “No Hands Zone” is an area 6 inches wide on
left and right side of the blade cutting path.
Portion of the Fence in this are also is considered
a part of the “No Hands Zone”.
The “No Hands Zone” for zero miter and zero bevel
cuts is marked on the tool with lines and “No
Hands” symbols – Figure 28 A.
The “No Hands Zone” for all slide and miter right
cuts is defined in Figure 28 B.
0
5
10
15
2
0
2
5
3
0
3
5
4
0
4
5
5
0
50
4
5
40
35
3
0
0
5
10
15
2
0
2
5
3
0
3
5
4
0
45
5
0
50
4
5
4
0
3
5
3
0
0
5
10
15
2
0
25
3
0
3
5
4
0
4
5
5
0
50
4
5
4
0
3
5
3
0
0
5
10
15
2
0
2
5
3
0
3
5
4
0
45
5
0
50
4
5
4
0
3
5
3
0
FIG. 27
CORRECT INCORRECT
 Switch Activation
For safety, the switch lever is designed to prevent
accidental starts. To operate safety switch, slide
t
he switch “Lock-OFF” release button with either
thumb to disengage the lock, then pull the power
switch trigger and release the switch “Lock-OFF”
release button (figure 26). When the power switch
trigger is released, the switch “Lock-OFF” release
b
utton will engage the power switch trigger
automatically, and the lever will no longer operate
until either “Lock-Off” release button is engaged
again.
NOTE: Power switch trigger can accommodate a
padlock with a long shackle of up to 3/16" in
diameter (not provided with miter saw) to prevent
unauthorized use.
Switch “Lock-OFF”
Release Button
Power
Switch
Trigger
FIG. 26
Padlock
Hole
Preparing for Saw Operations
6" 6"
6"
6"
FIG. 28 A
FIG. 28 B
2610051821.qxp_BM CM8S 9/19/18 2:55 PM Page 27

Bosch CM8S Specifications

General

Brand	Bosch
Model	CM8S
Category	Saw
Language	English