EasyManuals Logo

Bosch CM8S User Manual

Bosch CM8S
148 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #47 background imageLoading...
Page #47 background image
47
Cleaning
Certain cleaning agents and
solvents damage plastic
parts. Some of these are: gasoline, carbon
t
etrachloride, chlorinated cleaning solvents,
ammonia and household detergents that contain
ammonia.
Ventilation openings and switch levers must be
kept clean and free of foreign matter. Do not
attempt to clean by inserting pointed objects
through openings.
Check regularly to make sure the lower guard and
all moving parts are working properly.
Care of Blades
Blades become dull even from cutting regular
lumber. If you find yourself forcing the saw
forward to cut instead of just guiding it through
the cut, chances are the blade is dull or coated
with wood pitch.
When cleaning gum and wood pitch from blade,
unplug the saw and remove the blade. Remember,
blades are designed to cut, so handle carefully.
Wipe the blade with kerosene or similar solvent to
remove the gum and pitch. Unless you are
experienced in sharpening blades, we recommend
you do not try.
Tool Lubrication
Preventive maintenance
performed by unauthorized
personnel may result in misplacing of internal
wires and components which could cause serious
hazard. We recommend that all tool service be
performed by a Bosch factory Service Center or
Authorized Bosch Service Station.
Your Bosch tool has been properly lubricated and
is ready to use. It is recommended that tools with
gears be regreased with a special gear lubricant at
every brush change.
Periodically lubricate moving parts with a silicone,
or light oil spray. Do not use grease because it
tends to attract and hold sawdust.
Bearings
All bearings in this tool are lubricated with a
sufficient amount of high-grade lubricant for the
life of the unit under normal operating conditions.
No further lubrication is required.
Maintenance and Lubrication
Troubleshooting
PROBLEM CAUSE CORRECTIVE ACTION
Motor does not start. 1. Check that unit is plugged in.
2. Power source fuse or
time delay fuse.
3. Brushes worn.
4. Other.
- Plug unit in. Use different
outlet.
- 15-Amp time delay fuse or
circuit breaker.
- See Motor Brush Replacement
in the Maintenance and
Lubrication section.
- Authorized service.
Troubleshooting Guide - Electrical
To avoid accidents, alwaysdisconnect the tool from the power supply before cleaning or
p
erforming any maintenance.
2610051821.qxp_BM CM8S 9/19/18 2:55 PM Page 47

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bosch CM8S and is the answer not in the manual?

Bosch CM8S Specifications

General IconGeneral
BrandBosch
ModelCM8S
CategorySaw
LanguageEnglish

Related product manuals