Operation
13
Compress Hybrid 7000i AW – 6721833054 (2020/09)
3.3 Main menu
Depending on the heating appliance and how the user interface is used,
not all menu items will be available for selection; see overview of main
menu at the end of this document.
3.3.1 Heating settings
Menu: Heating/Cooling
Table 3 Heating settings
Adapting the Time program for the automatic mode
Menu: Time program
Table 4 Time program settings for heating
Setting the summer/winter switchover threshold
CAUTION
Risk of system damage!
▶ Do not switch over to summer mode if there is a risk of frost.
Menu: Summer/winter changeover
Table 5 Settings for the summer/winter changeover
3.3.2 DHW settings
Setting the operation mode for DHW heating
The installer sets the temperatures for the different modes.
Menu: Operating mode
Table 6 Settings for operation mode of DHW
Menu item Description
Operating mode Select the heating operating mode: optimised or
based on time program.
Temperature
settings
Temperatures for the levels Heating, Setback,
Optimised operation or Cooling can be set in this
menu.
Time program see Tab. 4
Summer/winter
changeover
see Tab. 5
DHW alternating
operation
see Tab. 5
Menu item Description
Activate time
program
Activating automatic mode triggers control of the
room temperature according to the settings in the
selected time program (My time program 1 or My
time program 2).
My time program 1 2 switching times can be set for each day or group
of days. One of the two operating modes (or a
temperature) can be assigned to each switching
time in automatic mode. The minimum duration of
a time slot between two switching times is
15 minutes.
Reset program The default setting for My time program 1 can be
restored here.
My time program 2 My time program 1
Reset program The default setting for My time program 2 can be
restored here.
Rename time
program
The names of the time programs can be changed in
the same way as the names of the heating circuits.
This helps to select the correct time program,
e.g. “family” or “night shift”.
Menu item Description
Heating/Cooling • In summer, heating/cooling mode can be
switched off (Continuous summer).
• The heating/cooling mode can be activated/shut
down based on the outside temperature
(this is only available if the Automatic modeis
active in the heating circuit).
• The heating mode can be active (Continuous
heating). However, heating starts only if it is too
cold inside.
• The cooling mode can be active (Continuous
cooling). However, cooling starts only if it is too
hot inside.
If more than one heating circuit is installed, Heating
circuit 1 ... 4 is displayed instead of this menu item.
Heating mode
from
1)
1) This menu item is only displayed if the outdoor-temperature-dependent
switching between summer and winter modes is active for the heating circuit
concerned.
If the outside temperature
2)
falls below the
temperature threshold set here, the heating system
is switched on. In systems with more than one
heating circuit, this setting always relates to the
corresponding heating circuit in each case.
2) When the outside temperature is adjusted (damped), changes to the measured
outside temperature are delayed and fluctuations reduced.
Cooling mode
from
If the outside temperature
2)
exceeds the
temperature threshold set here, the heating system
is switched off and cooling is enabled. In systems
with more than one heating circuit, this setting
always relates to the corresponding heating circuit
in each case.
Menu item Description
Operating mode • off: Deactivated, no DHW production.
• Always on - DHW Eco+: Lowest DHW
temperature mode that results in lowest energy
consumption.
• Always on - DHW Eco.: Medium DHW
temperature mode that results in medium energy
consumption.
• Always on - DHW comfort: Highest temperature
mode that results in higher energy consumption.
• Own time program: DHW time program that
operates independently of any heating circuit
time program.
To Next Page
Loading...
