1 689 989 091 2014-05-14| Robert Bosch GmbH
Operation | DCU 130 | 27 en
5.11 External DVD drive
(may be special accessory)
i This DVD player is a CLASS 1 LASER PRODUCT
5.11.1 Connection
i With a recessed USB port, it is not possible to con-
nect a DVD drive without its own power supply.
¶ Connect the USB connecting cable 1 684 465 682 to
the DVD drive and the two USB ports of the DCU 130
(Fig.4, Pos. 2).
The driver for the DVD drive is installed
automatically.
"The DVD drive can be used.
i Power is supplied by way of the USB connecting
cable 1 684 465 682 (max. 0.7 m). No power supply
unit is required.
5.11.2 Correct handling of DVD-ROMs
¶ Make sure hands are clean and not greasy when
inserting the DVD-ROM in the DVD drive.
¶ Never touch the unlabelled side of the DVD.
¶ Never write on the DVD or affix labels.
¶ Never use solvents such as spirit or paint thinners,
record cleaners or anti-static agents to clean
a soiled DVD.
¶ Carefully wipe off any finger marks or dust with
asoft cloth working outwards from the center.
¶ Never expose DVDs to high temperatures or direct
sunlight.
5.11.3 Inserting/removing DVD-ROM
1. Press the "DVD eject" button on the DVD drive to
eject and remove any DVD inserted.
2. Carefully insert the DVD with the labeled side facing
upwards.
i Clean the DVD drive at regular intervals with
acleaning disk for the CD-ROM or DVD drive
(refer also to Section 7.1.3).
5.12 Information on problems
Fault Explanatory notes
The DCU 130 cannot be switched
on and the display remains blank or
flickers.
The capacity of the internal battery is not sufficient to start the DCU 130.
Connect the external power supply unit.
The DCU 130 does not react to
any key commands.
1. Keep the ON key pressed for 5 seconds.
2. Switch on the DCU 130 again.
This switch-off procedure is only to be employed if the DCU 130 will not react to any key
being pressed, as it may result in loss of data on the hard disk if it is implemented during
regular operation. Data created in the course of this diagnostic application may have to be
entered again.
After clicking onto the touch screen
with the pen, the mouse pointer does
not appear at the same location
Touch screen calibration must be performed.
In the start bar under "START >> Control panel" call up the menu "ELO touch screen"
(refer to Section 6.2).
Operation by way of pen and touch
screen is no longer possible.
Touch screen calibration must be performed.
In the start bar under "START >> Control panel" call up the menu "ELO touch screen"
(refer to Section 6.2).
The software error message "No
connection to control unit" is
displayed.
In spite of correct connection of the diagnostic cable to the vehicle, the software error
message "No connection to control unit" may very occasionally appear. Possible causes:
R Control unit in vehicle not supported by software.
R Diagnostic cable / diagnostic tester incorrectly connected / defective.
The built-in Bluetooth driver is not in-
stalled, is deactivated or is not func-
tioning.
R Check if the “Bluetooth” hardware is activated ("Desktop >> Configuration Center >> Wi-
reless Configuration").
R Configure and test Bluetooth using DDC.
R Reinstall the Bluetooth driver
Double click on 'C:\DRIVERS\07-BLUETOOTH\MICROSOFT\INSTALL.BAT'
R Restart the PC/laptop to successfully conclude installation of the Bluetooth driver.
To Next Page
Loading...
