Bosch DSA E-Series (E2700) - Page 40

40 en | Installing the drive trays for the E2700 controller-drive tray configurations DSA E-Series (E2700)
2015.10 | V2 | DOC Installation manual Bosch Sicherheitssysteme GmbH
92015-00
1
1
2
2
2
2
1
1
4. With the help of at least two other persons, remove the drive tray and all of the contents
from the shipping carton, using the four drive tray handles (two to a side) as shown in the
following figure. Set the drive tray aside.
92015-02
5. Position the mounting rails in the cabinet.
– If you are installing the mounting rails above an existing tray, position the mounting
rails directly above the tray.
– If you are installing the mounting rails below an existing tray, allow 17.8 cm (7 in.)
vertical clearance.