Bosch DSA E-Series (E2700) - Page 41

DSA E-Series (E2700) Installing the drive trays for the E2700 controller-drive tray configurations | en 41
Bosch Sicherheitssysteme GmbH Installation manual 2015.10 | V2 | DOC
2
3
92011-01
1
4
1 - Screws for securing the mounting rail to the cabinet (front)
2 - Screws for securing the mounting rail to the cabinet (rear)
3 - Existing tray
4 - Industry standard cabinet
6. To attach the mounting rails to the cabinet, do one of the following: If you are using the
long fixed-size mounting rails, go to step 7.
If you are using the shorter adjustable mounting rails, go to step 8.
7. Attach the long fixed-size mounting rails to the cabinet.
– Make sure that the adjustment screws on the mounting rail are loose so that the
mounting rail can extend or contract as needed.
92011-00
3
1
2
6
7
8
5
4
9
1 - Front of the mounting rail
2 - Two M5 screws for the rear EIA support rail
3 - Front of the cabinet
4 - Two M5 screws for the front EIA support rail
5 - Adjustable rail tightening screws