Bosch FW 120 - Deleting an Individual Switching; Point; Resetting an Entire Program; Settings)

6 720 800 844 (2012/02)
Operation | 23
5.3.2 Deleting an individual switching point
B Place the highlight onto the value to be
deleted, as described in chapter , e.g.
parameter P1 (= switching point 1).
B Press .
The switching time and the associated
segment inside the segmented ring flashes.
B Press .
The deleted switching point flashes. At the
same time, the associated segments change.
B Press twice.
B Deleting P1 is now complete.
5.3.3 Resetting an entire program (overwriting
with factory settings)
B Call up menu: Heating > Programme,
Domestic hot water > DHW programme or
Domestic hot water > DHW circ pump prog .
B Turn until menu point is highlighted.
B Press .
No flashes.
B Turn until Yes flashes.
B Press .
The program was reset to its standard setting.
9
12
h
15
18
21
24
h
3
6
6 720 800 817-06.1O
6 720 800 817-09.1O
9
12
h
15
18
21
24
h
3
6