-2-
The definitions below describe the level of severity for each signal word.
Please read the manual and pay attention to these symbols.
!
This is the safety alert symbol. It is used to alert you to potential per-
sonal injury hazards. Obey all safety messages that follow this symbol
to avoid possible injury or death.
DANGER indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION indicates a hazardous situation which, if not avoided, could
result in minor or moderate injury.
Table of Contents
Safety Symbols
Safety Symbols ......................2
General Power Tool Safety Warnings .....3
Safety Instructions for Miter Saws . . . . . . . 5
Additional Safety Rules................7
Symbols ...........................8
Getting to Know Your Miter Saw........10
Specifications ......................14
Intended Use ......................14
Cutting Masonry/Metal ............14
Cutting Capacities ..................15
Unpacking and Checking Contents......16
Unpacking the Miter Saw ..........16
Checking Contents in Package ......16
Tools Needed For Assembly ...........17
Verifying Parts...................17
Checking Combination Square ......17
Assembly..........................18
Storing the Torx Wrench ...........18
Inserting and Releasing Battery
Pack........................18
Removing and Installing Blades .....19
Assembling Dust Collection
System......................20
Adjustments .......................22
Using the Head Assembly Lock Pin ...22
Miter Detent System – Adjustment
Procedure ...................23
0° Bevel Stop ...................24
45° Bevel Stop ..................25
Transporting and Mounting ...........27
Lifting the Saw ..................27
Mounting Applications ............28
Preparing for Saw Operations .........29
Switch Activation ................29
Built-in LED Light ................29
Body and Hand Position ...........29
Workpiece Support ...............32
Saw Operations ....................34
Brake Operation .................34
Using the Miter Lock Knob .........34
Using Miter Detent System .........34
Chop Cuts ......................35
Slide Cuts ......................36
Miter Cuts ......................37
Bevel Cuts......................38
Compound Cuts .................40
Cutting Base Molding .............41
Cutting Crown Molding............42
16099221PK GCM18V-07S OSI 20220506.indd 2 5/6/22 11:27 AM
To Next Page
Loading...
