-41-
Cutting Base Molding
Base molding can be cut vertical against fence
or flat on the table. The maximum size that can
be vertical on the fence is 3-3/4” (95mm), flat
on table is 8-1/4” (210mm).
See the “Base Molding Cutting Instructions” ta-
ble below for helpful hints on cutting base mold-
ing for corners that have 90° angles.
Saw Operations
Base Molding Cutting Instructions
LOCATION OF
MOLDING ON SAW
Molding in Vertical Position:
Back of molding is against
the fence
Molding in Horizontal
Position: Back of molding is
flat on the table
Bevel Angle Bevel = 0º Bevel = 45º
Molding piece being cut
To left of
corner
To right of
corner
To left of
corner
To right of
corner
Inside corner
of wall
Miter Angle Left at 45º Right at 45º 0º 0º
Position of
molding on
saw
Bottom
against table
Bottom
against table
Top against
fence
Top against
fence
Finished side
Keep left
side of cut
Keep right
side of cut
Keep left
side of cut
Keep left
side of cut
Outside
corner of
wall
Miter Angle Right at 45º Left at 45º 0º 0º
Position of
molding on
saw
Bottom
against table
Bottom
against table
Bottom
against fence
Top against
fence
Finished side
Keep left
side of cut
Keep right
side of cut
Keep right
side of cut
Keep right
side of cut
Cutting base molding can be done either as a
chop cut or a slide cut depending on the size of
the workpiece. (See “Chop Cuts” on page 35
or “Slide Cuts” on page 36.)
16099221PK GCM18V-07S OSI 20220506.indd 41 5/6/22 11:27 AM
To Next Page
Loading...
