18
Assembly
Attaching Loose Parts
Attaching the Miter Lock Knob – Locate
the miter lock knob 12 from among the
loose parts.
1. Look under the turntable’s front arm
above the lock lever and locate the
10mm hole (see Fig. 1).
2. Insert the long shaft of the miter lock
knob through this hole until it stops.
3. Turn the knob clockwise (about 10 full
revolutions) until it is tight or “locked.”
4. Loosen the knob 1/2 turn to unlock it.
The table is now free to be moved on the
base.
Using the Miter Lock Knob –
1. Loosen the miter lock knob.
2. While holding the knob in your palm,
reach down with your index or middle
finger and pull up the detent lever. While
gripping knob, rotate table left or right
to needed miter angle and release the
lever.
3. Tighten the knob once you are at the cor-
rect angle.
NOTE: It is recommended to tighten the
miter lock knob before all cuts. It is re-
quired to tighten the knob before cutting at
any angle between detent engagements or
when the miter detent override system is in
use.
Storing the 6/4mm Hex Key – There is a
storage location on the saw to store the
6/4mm hex key. Insert the short leg of the
hex key through the rubber grommet as
shown. Place the long leg into the tool rest
and press down into the retainer clip (see
Fig. 2).
NOTE: The 6/4mm hex key is needed to
change the blade and to make tool adjust-
ments. If lost, two separate hex keys may
be substituted: a 4mm hex key and a 6mm
hex key.
Inserting and Releasing
Battery Pack
Slide charged battery pack 47 into the bat-
tery bay 46 until the battery pack locks into
position (Fig. 3).
To avoid possible injury, disconnect battery pack before performing any as-
sembly, adjustments or repairs.
To Next Page
Loading...
