41
Using Miter Detent System
1. Loosen the miter lock knob 12 about 1/2
turn.
2. Grip the lock knob, and then reach down
with your index finger to pull up on the
miter detent lever 13 – pull lever until it
is out from the detent plate.
3. While gripping the lock knob and lever,
rotate the saw’s table. Stop table rota-
tion at the desired angle as indicated by
the miter scale pointer 15.
4. Release the lever into a detent 17 in the
detent plate 16 or at an angle between
detents. If close to a detent, use the de-
tent override feature.
5. Tighten the miter lock knob before cut-
ting.
NOTE: It is recommended to tighten the
miter lock knob before all cuts. It is re-
quired to tighten the knob before cutting at
any angle between detents or when the
miter detent override system is in use.
Miter Detent Override
The miter detent override feature allows the
miter detent action to be locked out, allow-
ing for micro adjustments at any miter
angle. When the desired miter angle is too
close to a standard mitering angle that has
a detent slot, this feature prevents the
wedge on the miter detent lever from slip-
ping into the detent slot on the miter detent
plate.
1. Lift and hold the miter detent lever 13.
2. Push the detent override clip 11 forward
and latch in place over receiving edge on
turntable arm. Release miter detent lever
(Fig. 41).
3. Rotate table to any position on the miter
scale.
4. Lock the miter lock knob to retain miter
position.
To Disengage:
Loosen miter lock knob and lift the miter
detent lever to release the detent override
clip. The clip should automatically disen-
gage and the table should lock into any de-
sired miter detent.
To Next Page
Loading...
