61
Troubleshooting
PROBLEM CAUSE CORRECTIVE ACTION
Brake does not stop blade in
about 5 seconds.
1. Blade bolt loose.
2. Other.
1. Tighten blade bolt.
2. Authorized service.
Motor does not start. 1. Battery pack not charged.
2. Battery pack not installed
properly.
3. Battery pack temperature
is too hot or cold for oper-
ation.
4. Electronic Motor Protec-
tion turned tool off.
5. Burned out switch.
6. Other.
1. Charge battery if needed.
2. Confirm battery is locked
and secured to the tool.
3. Let battery sit a few min-
utes or until it reaches nor-
mal operating temperature.
4a. Remove battery an replace.
4b. Let tool sit a few minutes
or until it reaches normal
operating temperature.
5. Have switch replaced by an
Authorized Bosch Service
Center or Service Station.
6. Authorized service.
Troubleshooting Guide - Electrical
To Next Page
Loading...
