34
Preparing for Saw Operations
User Interface (Fig. 30)
The user interface 50 is used to select the
preset speed levels and to indicate the sta-
tus of the power tool and battery.
ECO MODE
When full power is not needed, the saw’s
energy-saving ECO mode can be used to re-
duce the saw’s output power in order to ex-
tend the runtime.
If the ECO mode is active, the speed
level/mode indicator 50d displays the sym-
bol “E” and “ECO” icon 50b lights up.
SPEED PRESETS
The speed settings and the ECO mode are
preprogrammed and can be adjusted via
the ‘Bosch Toolbox’ app. For more informa-
tion on the ‘Bosch Toolbox’ application,
refer to the “Connectivity” chapter on the
next page. The table below describes the
preset speeds and ECO mode speed.
BATTERY CHARGE INDICATOR
When the battery charge indicator 50a is
glowing green, the battery is charged and
the number of bars shows the level of the
charge.
Glowing yellow and only one bar indicates
that the battery needs to be charged or re-
placed soon.
Glowing red and only one bar means that
the battery charge is depleted.
TEMPERATURE INDICATOR
If the temperature indicator 50g is glowing
yellow, the critical temperature of the
motor, electronics or battery has been
reached. Run the power tool at no load and
allow it to cool down.
If the temperature indicator is glowing red,
power tool is overheated and will switch
off. Allow the power tool to cool down.
SMARTPHONE STATUS INDICATOR
It is necessary to purchase and install a
Bosch connectivity module and install the
'BoschToolbox' app to receive information
and messages as alerted by the smart-
phone status indicator. See the Connectiv-
ity chapter on the next page.
Green Smartphone status indicator 50e
means that there is non-critical information
available in the 'Bosch Toolbox' app for user
to read.
Yellow smartphone status indicator 50e
means that there is important information
available (e.g. temperature warning).
Red smartphone status indicator 50e
means that there is critical information
available. It is recommended that the user
reviews the message immediately.
POWER TOOL STATUS FRAME
Green light of the power tool status frame
50f means everything is functioning prop-
erly.
Yellow light means that:
a. Critical temperature has been reached
(the temperature indicator 50g is also
glowing yellow) - run the tool at no load
and allow it to cool down, or
b. Battery is almost depleted (the battery
charge indicator 50a is also glowing yel-
low) - charge or replace the battery
soon.
Red light means that:
a. The tool is overheated (the temperature
indicator 50a is glowing red) – turn the
tool off and on again, or
b. Battery is depleted (the battery charge
indicator 50a is also glowing red) -
charge or replace the battery.
Flashing blue light means that the power
tool is connected to a mobile device or set-
tings are being transferred. The user must
press the user interface button 50c to ac-
cept and store the new setting(s).
To Next Page
Loading...
