49
Bevel Range 2 = 0-45° Right
To operate in Bevel Range 2:
1. Move the right sliding fence out to clear
saw assembly and relock (see Fig. 51).
2. Lift bevel lock lever above table height
with the left hand.
3. Grasp the main handle with the left hand
and tilt the saw assembly slightly to the
left while rotating the spring-loaded
bevel range selector knob with the right
hand so the knob’s indicator points to
“0-45° Right” as on the label.
4. Once in the desired bevel position, hold
the saw assembly with right hand and
use left hand to fully press down the
bevel lock lever below table height.
NOTE: When the saw assembly is tilted
back to left past 0°, the bevel control knob
will snap back to the default bevel range 1.
This is designed to regain the preset bevel
stop at the important 0° position.
Bevel Range 3 = Max. Bevel Angle to 47°
Left or Right
This full-capacity bevel range setting over-
rides all preset stops and allows for cutting
at bevel angles beyond the normal 45° on
either side.
To operate in Bevel Range 3:
1. Move the left and right sliding fences out
to clear saw assembly and relock (see
Fig. 51).
2. Lift bevel lock lever above table height
with the left hand.
3. Grasp the main handle with the left hand
and tilt the saw assembly slightly to the
left while rotating the spring-loaded
bevel range selector knob with the right
hand so the knob’s indicator points to
the red square below “Max. Bevel Angle
to 47° Left or Right.”
4. Once in needed bevel position, hold saw
head by the right hand and use left hand
to press down the bevel lock lever below
table height.
NOTE: The selector knob will stay in this
“override” position. Turn the knob slightly
clockwise and it will snap back to bevel
range 1 (default position).
Saw Operations
To Next Page
Loading...
