Bosch GCM18V-12GDCN - Page 56

56
Miter and Bevel Settings for Standard Crown Molding Cuts
(With Molding Flat on Table)
Assumptions: Molding is milled consistently. Corner is exactly 90°.
Molding Spring Angle 38° Molding Spring Angle 45°
Note: Always place top
edge against fence
Miter (Table)
Setting
Bevel (Tilt)
Setting
Miter (Table)
Setting
Bevel (Tilt)
Setting
Inside Corner -
Left end
Use the left end of the cut
31.6° Right 33.9° Left 35.3° Right 30° Left
Right end
Use the right end of the cut
31.6° Left 33.9° Right 35.3° Left 30° Right
Outside Corner -
Left end
Use the left end of the cut
31.6° Left 33.9° Right 35.3° Left 30° Right
Right end
Use the right end of the cut
31.6° Right 33.9° Left 35.3° Right 30° Left
Saw Operations
Fence
Table
Top of Molding
Against Fence
Ceiling
45° Spring Angle
38° Spring Angle
52°45°
38°
45°
Wall
Ceiling
Wall
45/45° Crown
Molding
38/52° Crown
Molding
Inside
Corner
Outside
Corner
1609B06757.qxp_GCM18V-12GDC 3/25/20 12:35 PM Page 56
www.calcert.com sales@calcert.com1.800.544.2843
0
5
10
15
20
25
30