48
1-3/16" 1-3/16"
7/8"
FOLLOW STEPS:
1
2
MITER GAUGE TEMPLATE - FOR ADDING MOUNTING HOLES
(FOR ATTACHMENT OF AUXILIARY FACING)
Drill 2 holes - 1/4" diameter through
both walls (first drill smaller pilot holes)
1
2
TAPETAPE
TAPE TAPE
Cut out template around outside edges,
place over face of the miter guage,
as shown above, and tape down.
1600A009XC 09-15.indb 48 9/14/15 1:51 PM
To Next Page
Loading...
