Table of contents
1
Safety 4
2
Introduction 5
2.1 About documentation 5
2.2 Bosch Security Systems, Inc. product manufacturing dates 5
3
Detector overview 6
4
Installation considerations 7
5
Installation 10
5.1 Self-locking cam lock 10
5.2 Mounting options 11
5.3 Wire knockouts 13
5.4 Bubble level 14
6
Wiring 16
6.1 Wiring overview 16
6.2 EOL resistors overview 17
6.3 EOL resistor loop combinations 19
6.3.1 Single EOL loop — Alarm and Tamper 19
6.3.2 Double EOL loop — Alarm and Tamper 20
7
Configuration and walk test 21
7.1 Look-down zone 21
7.2 Walk test LED 21
7.3 Walk test 22
7.3.1 Establish the coverage pattern 22
7.3.2 Establish the PIR and microwave coverage 23
7.3.3 Adjustable PIR sensitivity 23
7.3.4 Adjustable microwave sensitivity 24
7.4 Self test 24
8
Troubleshooting 25
8.1 Motion detector does not appear to respond to motion 25
8.2 Motion detector is in continuous alarm 25
8.3 Motion detector appears normal but does not send alarms to the control panel 25
8.4 Motion detector does not appear to detect motion in the space directly under it 25
8.5 Motion detector does not appear to detect motion near the edge of the coverage area 25
8.6 Motion detector does not appear to detect motion in the farther section of the coverage
area
25
8.7 Motion detector LED flashes continuously 26
8.8 Motion detector LED flashes four times in a row repeatedly 26
8.9 Motion detector LED flashes five times in a row repeatedly 26
9
Specifications 27
9.1 Coverage pattern 27
Commercial Series TriTech Motion
Detector
Table of Contents | en 3
Bosch Security Systems, Inc Reference Guide 2015.06 | 02 | F.01U.314.294
To Next Page
Loading...
Need help?
General
