14 en | Introduction MIC IP ultra 7100i │ MIC IP starlight 7100i
2019-07-03 | 0.17 | Installation Manual Bosch Security Systems
2.1 Parts List - Camera
Quantity Component
1 MIC IP ultra 7100i camera
1 spanner tool [to remove and to attach the yoke caps in order to cant the
camera if desired, and to remove the access plug from the camera head
when installing the optional illuminator accessory (sold separately)]
1 base gasket
1 RJ45 coupler
1 MAC address labels
1 Quick Installation Guide
1 Safety instructions
2.2 Additional Tools
The following table lists additional tools (not supplied by Bosch) that may be required to
install a MIC camera or its accessories:
1 Phillips-head screwdriver to secure the ground lug of the camera
1 Adjustable wrench or socket set to secure the base of the camera to mounting accessories
For canting cameras:
1 Torque wrench with a 5 mm Hex bit to remove/install bolts in the yoke arms
For installing an optional SD card on MIC enhanced models (MIC-7504-Z12xR, MIC-7522-
Z30xR):
a T20 Torx bit
To Next Page
Loading...
