24 en | (Optional) Installing an SD card MIC IP ultra 7100i │ MIC IP starlight 7100i
2019-07-03 | 0.17 | Installation Manual Bosch Security Systems
6 (Optional) Installing an SD card
The steps that follow are applicable for MIC enhanced models (MIC-7504-Z12xR, MIC-7522-
Z30xR).
1. Use a T20 Torx driver to remove the two (2) fasteners from the SD card cover on the rear
of the camera head.
2. Pull off the SD card cover. Allow the cover and the O-ring seal to hang loose from the
tether.
Note: Do not drop the fasteners.
3. Install a standard SD card.
4. If necessary, put the O-ring seal into the cover.
5. Put on the cover.
6. Install the two (2) fasteners that you removed in step 1.
7. Tighten the fasteners to 1.8 N m (1.3 ft lb).
To Next Page
Loading...
