Bosch MIC IP ultra 7100i - Page 40

40 en | (Optional) Canting the Camera MIC IP ultra 7100i │ MIC IP starlight 7100i
2019-07-03 | 0.17 | Installation Manual Bosch Security Systems
Figure12.3: Cant the camera head.
6. Reinsert the screws into both yoke arms. Note the letter assigned to each screw in the
figure below.
C
D
B
A
Figure12.4: Reinsert the screws in the yoke arms in the following sequence: ABCD.
7. Using a torque wrench (user-supplied), tighten the screws to the proper torque using the
sequence described in the table below.
8. Recheck all four screws to ensure the proper torque value.
Do not use grease on the screws.
1.
2.
5mm Hex
(T30 Torx)
7.5 Nm
(5.5 ft lb)
17 Nm (12.5 ft lb)
3.
4.
D
B
D
A
C
DC
C
BA
BA
DC
BA
17 Nm (12.5 ft lb)
17 Nm (12.5 ft lb)
9. Attach the yoke caps using the supplied spanner wrench.
Note: Tighten each yoke cap until it is flush with the yoke arm.