EasyManua.ls Logo

Bosch MIC IP ultra 7100i - Ipv4 Filter

Bosch MIC IP ultra 7100i
86 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MIC IP ultra 7100i │ MIC IP starlight 7100i Network | en 59
Bosch Security Systems
User Manual
2020-11 | 1.4 |
Port
Enter the port address for the stream here.
Streaming
Click the checkbox to activate multicast streaming mode. An activated stream is marked with a
check. (Streaming is typically not required for standard multicast operation.)
Multicast packet TTL
You can enter a value to specify how long the multicast data packets are active on the
network. This value must be greater than one if multicast is to be run via a router.
IGMP version
You can define the multicast IGMP version to comply with the device.
Click Set to apply the changes.
8.7 IPv4 Filter
Use this setting to configure a filter that allows or blocks network traffic that matches a
specified address or protocol.
IP Address 1 / 2
Enter the IPv4 address that you want to allow or block
Mask 1 / 2
Enter the subnet mask for the appropriate IPv4 address.

Table of Contents

Other manuals for Bosch MIC IP ultra 7100i

Related product manuals