Bosch Pack201HS - 2.3 Safety Equipment

Pack201 | Section 2 | Safety
© Bosch Packaging Technology, Inc.
All rights reserved 2012
EN | 3
2.3 Safety Equipment
2.3.1 Emergency Stop Button
If an emergency stop button is pushed, the wrapper
will stop immediately without regard for the machine
position and timing. When the button is pushed, it
will remain in. The button must be either turned or
pulled out again before the wrapper can be started.
This button should be pushed in and the power source
disconnected and locked out before performing
any cleaning, maintenance or mechanical setup
procedures.
This button should not be used for normal stop
situations. Its may cause the wrapper to lose
synchronization.
2.3.2 Safety Interlocks
To prevent accidents, the wrapper is tted with safety
interlocks on the guards that must be kept closed dur-
ing operation.
Unauthorized opening of any interlocked guard leads
to an immediate stoppage of the wrapper. Do not use
these guards for a regular cycle stop.