Bosch Plena - 20 Voice Alarm Router; Introduction; Router ID; Termination Switch

Bosch Security Systems | 2006-06 | 9922 141 10377 en
Plena Voice Alarm System | Installation and User Instructions | Configuration en | 81
20 Voice alarm router
20.1 Introduction
The voice alarm routers are configured using an ID
selector and a DIP switch (see figure 20.1).
20.2 Router ID
The ID of the voice alarm router is set using an ID
selector. Each voice alarm router must have a unique ID
(1 to 9). Use a small screwdriver to turn the arrow in the
correct position.
20.3 Termination switch
The last voice alarm router in a sequence of
looped-through routers must always be terminated.
Only for these voice alarm routers, put the Termination
switch in the ON position.
figure 20.1: Router settings
1...9
ID
Router
Booster 2
In
Out
Firmware upgrade
Firmware Upgrade
Termination
Off
On