Bosch Security Systems | 2006-06 | 9922 141 10377 en
Plena Voice Alarm System | Installation and User Instructions | Configuration en | 83
22 Remote control
22.1 Introduction
The remote controls are configured using a DIP switch
(see figure 22.1).
22.2 Remote control ID
The ID of the remote control is set using the RCP ID
switch. The ID of the remote control must be the same
as the number of the Remote Control Panel connection
of the voice alarm controller to which the remote
control is connected (1 to 2). Actions that are started by
the remote control with ID 1 have a higher priority than
actions that are started by the remote control with ID 2.
22.3 Monitor
If the Monitor switch is in the ON position, the internal
monitoring loudspeaker of the remote control is
switched on. The volume of the monitoring loudspeaker
is set with the Monitoring Speaker volume control on the
rear panel of the remote control.
22.4 Termination switch
If there are no remote control extensions connected to
the remote control, the Termination switch must be in
the ON position.
23 Remote control extension
23.1 Introduction
The remote control extensions are configured using an
ID selector and a switch (see figure 23.1).
23.2 Remote control extension ID
The ID of the remote control extension is set using a ID
selector. The remote control extension only controls the
voice alarm router that has the same ID. Furthermore,
each remote control extension that is connected to the
same remote control must have a unique ID (1 to 9).
23.3 Termination switch
The last remote control extension in a sequence of
looped-through remote control extensions must always
be terminated. Only for these remote control
extensions, put the Termination switch in the ON
position.
figure 22.1: Remote control settings
figure 23.1: Remote control settings
6
1...9
ID
1
2
3
4
5
7
9
8
RCP ext. In RC P ext.
Off
On
Termination
To Next Page
Loading...
