Need help?Do you have a question about the Bosch Plena and is the answer not in the manual?
General| Brand | Bosch |
|---|---|
| Model | Plena |
| Category | Security System |
| Language | English |
Prior to installing or operating products, read the separate Important Safety Instructions document.
Overview of the Plena Voice Alarm System's features and compliance with evacuation standards.
Describes the Controller's role, microphone, amplifier, message manager, supervision, and trigger inputs.
Details remote control capabilities and various connection sockets for peripherals.
Provides a detailed overview of the front and rear views, including buttons, LEDs, and switches.
Explains how routers expand system zones and trigger inputs, and their connection.
Details the front and rear views of the Voice Alarm Router, including indicators and connections.
Introduces the Call Station for business calls and its maximum number in a system.
Details indicators, connectors for keypads, power supply, and system sockets.
Overview of the remote control unit for managing the system from a distance.
Details fault indicators, state buttons, and zone selectors on the remote control.
Details the remote control extension for expanding system reach and its kit version.
Describes the Fireman’s Panel for emergency control, including its buttons and indicators.
Details fault indicators, ground connection, firmware upgrade, and extension sockets.
Describes table-top and rack-mounting installation for the Voice Alarm Controller.
Details table-top and rack-mounting installation for the Voice Alarm Router.
Covers installation of remote controls and remote control kits, including rack-mounting.
Details installation of remote control extensions and their kits, including rack-mounting.
Explains connecting call stations using CAT-5 Ethernet cables and CAN bus termination.
Details connecting voice alarm routers to the controller using shielded CAT-5 cables.
Explains connecting loudspeakers to the 6 zone outputs, including redundant lines.
Describes the 6 override outputs for 4-wire and 3-wire override and their connections.
Covers connecting the controller to mains power, voltage selection, and back-up power supply.
Describes router connections to the controller, loudspeakers, overrides, and trigger inputs.
Details connecting remote control extensions to the remote control.
Describes connecting remote control extensions to the remote control and power supply.
Details connecting the fireman’s panel to the controller and remote control extensions.
Explains DIP switch settings on the controller for monitor, APR mode, supervision, and 2ch operation.
Details the functions of the Monitor, APR mode, and Supervision switches.
Describes how the system operates in 1-channel and 2-channel modes with different amplifier configurations.
Explains supervision enabling and the Disabled indicator when supervision is off.
Details line supervision including impedance and short-circuit monitoring of loudspeaker lines.
Procedure for switching on the voice alarm controller and voice alarm router.
Details entering, acknowledging, and exiting the emergency state.
Explains handling fault states: acknowledgement, reset, and fault indicators.
Provides solutions for common problems like no sound, pilot tone issues, and BGM problems.
Addresses issues like clicks, password errors, configuration download failures, and USB port problems.
Guidelines for keeping the system in good condition: cleaning units, air inlets, and checking connections.
To Next Page