Relays
To the LEDs/LAMPS connectors on the front panel of the remote control extension kit, relays
can be connected (see Voice Alarm Remote Control kit, page 27).
Fireman’s Panel
Voice alarm controller
Connect the fireman’s panel to the voice alarm controller (see section Remote controls, page
53).
Remote control extensions
The fireman’s panel has 1 socket for remote control extensions (Remote Control Extension,
Remote Control Extension kit). Use shielded CAT‑5 Ethernet cables with RJ45 plugs to
connect a remote control extension to the fireman’s panel. When the system requires more
than 1 remote control extension, use the system sockets on the remote control extension to
make loop‑throughs. See section Remote control extensions, page 70 for connection details.
Status output contacts
The fireman’s panel has 3 status output contacts to indicate the current system state. The
procedure for connecting the status outputs is the same as the procedure for connecting
status outputs to the voice alarm controller (see section Status output contacts, page 61).
Power
The procedure for connecting a fireman’s panel to a power supply is the same as the
procedure for connecting a remote control to a power supply (see section Power, page 71).
5.7.4
5.8
5.8.1
5.8.2
5.8.3
5.8.4
74 en | Connection Plena
2013.07 | V2.0 | Installation and Operation manual Bosch Security Systems B.V.
To Next Page
Loading...
