Bosch Plena - Select Zones

Select zones
Select the zones to which the live speech must be distributed with the Zone select buttons on
the front of the voice alarm controller or the remote controls. A red LED indicates the zones to
which the live speech is distributed.
– If the indicator of a Zone select button is off, the zone is not selected. Push the button to
select the zone.
– If the indicator of a Zone select button is on, the zone is selected. Push the button to
deselect the zone.
Notice!
If no additional action is taken within 10 seconds after the last Zone select button has been
pushed (for example closing the PTT switch), the zone selection is cancelled.
Zone select
Zone1 Zone2
Fault
Reset
EMG
Ack
Figure 7.11: Zone select buttons
To select all zones, push the All call buttons on the front of the voice alarm controller or the
remote controls.
Indicator test
EMG mic
All call
Alert message
Alarm message
Figure 7.12: All call button
7.4.5
Plena Operation | en 93
Bosch Security Systems B.V. Installation and Operation manual 2013.07 | V2.0 |