Bosch Plena - Voice Alarm Remote Control; Remote Control Indicators and Buttons

Voice Alarm Remote Control
0 dB
-6dB
-20dB
Processor reset
Network
Call/EMG
Music/Spare
Ground short
Input
Mains
Battery
Zone1
Zone2
Zone3
Zone4
Zone5
Zone6
Alarm
Zone select
Plena Voice Alarm Remote Control
Fault Indicators
Zone select
Indicator test
EMG mic
Alert message
Alarm message
All call
Zone1 Zone2 Zone3 Zone4 Zone5 Zone6
Fault
EMG
Ack
Reset
A
B
Disabled
Message
EMG mic
RCP
Router
Design & Quality
The Netherlands
NL-4827HG-10
Plena Voice Alarm System
RC Panel
Max. input power
300mA, 24V DC
S/N.
PLN-V6RC
A035413
Made in China
N663
8900 199 60001
1
2 3 4 5
69121314
15171820
710
16192122232425
811
Figure 3.9: Front and rear views of the voice alarm remote control
Controls, connections and indicators on the remote control:
1. Power LED/VU Meter:
A combined power indicator and VU meter. The green power LED is lit if the remote
control is connected to the power supply. The VU meter indicates the call level: 0 dB
(red), -6 dB, -20 dB (yellow).
2. Fault indicators:
Twelve yellow system fault LEDs (Processor reset, Network, Call/EMG, Music/Spare,
Ground short, Input, Mains, Battery, Message, EMG mic, RCP and Router) and twelve
yellow loudspeaker line fault LEDs. Fault indication is only possible if supervision is
enabled (see section Fault indicators, page 98). If supervision is disabled, the yellow
Disabled LED is lit.
3. Fault state buttons:
Two buttons to acknowledge (Ack) and reset (Reset) the fault state (see section Fault
State, page 96).
4. Emergency state buttons:
Two buttons to acknowledge (Ack) and reset (Reset) the emergency state (see section
Emergency state, page 91).
3.6
Plena System overview | en 25
Bosch Security Systems B.V. Installation and Operation manual 2013.07 | V2.0 |