7. Firmware upgrade switch:
A switch to upgrade the firmware of the remote control extension.
8. System sockets:
One RJ45 socket to connect the remote control extension to the remote control (see
section Remote control extensions, page 70).
9. Configuration settings:
A termination switch for the Remote Control Extension and 0-9 / 10-19 switch (see
section Remote control extension, page 86).
10. Remote control extension ID:
A rotary switch to set the ID of the remote control extension (see section Remote control
extension, page 86).
11. Trigger outputs:
Three general purpose trigger outputs. For future use.
12. Status output:
One status output to send the status of the Plena Voice Alarm System to third party
equipment (see section Status output contacts, page 73).
13. 24 V DC input:
One 24 V(DC) input to connect the remote control panel to a power supply (see section
Power, page 73).
Remote Control Extension kit
With the Voice Alarm Control Extension Kit, it is possible to make customized remote control
extensions that can be connected to a remote control (Fireman’s Panel, Remote Control,
Remote Control kit). The remote control extension kit provides the same functionality as the
Voice Alarm Remote Control Extension.
The rear panel of the remote control extension kit is the same as the rear panel of the Voice
Alarm Remote Control Extension (see Remote Control Extension, page 28).
To Next Page
Loading...
