Bosch Plena - Remote Control Extension Configuration

Remote control extension
The remote control extensions are configured using an ID selector and a switch:
6
1...9
ID
1
2
3
4
5
7
9
8
RCP ext. In RCP ext. Out
Off
On
Termination
3
Figure 6.9: Remote control settings
Remote control extension ID
The ID of the remote control extension is set using a ID selector. The remote control extension
only controls the voice alarm router that has the same ID. Furthermore, each remote control
extension that is connected to the same remote control must have a unique ID.
Termination switch
The last remote control extension in a sequence of looped-through remote control extensions
must always be terminated. Only for these remote control extensions, put the termination
switch in the ON position.
Notice!
The Controller comes with a termination plug (RJ45). Plug this connector in the unused RJ45
socket.
6.6
6.6.1
6.6.2
86 en | Configuration Plena
2013.07 | V2.0 | Installation and Operation manual Bosch Security Systems B.V.