Remote control
The remote controls are configured using a DIP switch:
Figure 6.8: Remote control settings
Remote control ID
The ID of the remote control is set using the Remote Control Panel ID switch. The ID of the
remote control must be the same as the number of the RCP connection of the voice alarm
controller to which the remote control is connected (1 to 2). Actions that are started by the
remote control with ID 1 have a higher priority than actions that are started by the remote
control with ID 2.
Monitor
If the Monitor switch is in the ON position, the internal monitoring loudspeaker of the remote
control is switched on. The volume of the monitoring loudspeaker is set with the Monitoring
Speaker volume control on the rear panel of the remote control.
Termination switch
If there are no remote control extensions connected to the remote control, the termination
switch must be in the ON position.
6.5
6.5.1
6.5.2
6.5.3
Plena Configuration | en 85
Bosch Security Systems B.V. Installation and Operation manual 2013.07 | V2.0 |
To Next Page
Loading...
