Bosch Plena - Page 93

Bosch Security Systems | 2006-06 | 9922 141 10377 en
Plena Voice Alarm System | Installation and User Instructions | Operation en | 93
27.5.3 Make the announcement
Push the push-to-talk (PTT) button of the emergency
microphone to make an announcement (see figure 27.6).
The live speech is only distributed to the selected zones
(see section 26.2). At the moment the PTT button of the
emergency microphone is pushed:
• The red EMG mic indicator is lit (see figure 27.7).
• If they are currently distributed, the default alert
message and default alarm message are stopped.
27.5.4 Distribute the alert message
27.5.4.1 Introduction
Proceed as follows to distribute the default alert
message:
• Select the zones (see section 27.5.4.2).
• Start the alert message (see section 27.5.4.3).
27.5.4.2 Select zones
Select the zones to which the default alert message must
be distributed with the Zone select buttons on the front
of the voice alarm controller or the remote controls (see
figure 27.4). A red LED indicates the zones to which the
default alert message is distributed.
• If the indicator of a Zone select button is off, the
zone is not selected. Push the button to select the
zone.
• If the indicator of a Zone select button is on, the
zone is selected. Push the button to deselect the zone.
Note
If no zones have been selected, the live speech
is automatically distributed to all zones in the
system.
figure 27.6: Emergency microphone
figure 27.7: Emergency microphone indicator
Indicator test
EMG mic
Alert message
Alarm message
All call
Note
If no additional action is taken within
10 seconds after the last Zone select button has
been pushed (for example pushing the Alert
message button), the zone selection is
cancelled.
figure 27.8: Zone select buttons
Zone select
Zone1 Zone2
Fault
Reset
EMG
Ack