Bosch Rexroth Hagglunds CBm - Fluid Contamination, Cleaning, and Disposal

12/72 General notes regarding property damages and product damages
Bosch Rexroth AB, RE 15300-WA, Version 06.2021
NOTICE
Contamination of the hydraulic uid
The cleanliness of the hydraulic uid has a considerable impact on the
cleanliness and service life of the hydraulic system. Contamination of the
hydraulic uid could cause premature wear and malfunctions.
▶ Make sure that the working environment at the installation site is fully free of
dust and foreign substances in order to prevent contaminants, such as welding
beads or metal cuttings, from getting into the hydraulic lines and causing
product wear or malfunctions. The Hägglunds motor must be installed in a
clean condition.
▶ Use only clean connections, hydraulic lines and attachments (e.g. measuring
equipment).
▶ No contaminants may enter the connections when they are plugged.
▶ Before commissioning, make sure that all hydraulic connections are tight and
that all of the connection seals and plugs are installed correctly to ensure that
they are leakproof and uids and contaminants are prevented from penetrating
the product.
▶ Use a suitable lter system to lter hydraulic uid during lling to minimize
solid impurities and water in the hydraulic system.
Improper cleaning
Product can be damaged.
▶ Plug all openings with the appropriate protective equipment in order to
prevent detergents from entering the hydraulic system.
▶ Never use solvents or aggressive detergents. Use only water and, if necessary,
a mild detergent to clean the Hägglunds motor.
▶ Do not point the power washer at sensitive components, e.g. shaft seal,
electrical connections and components.
▶ Use lint-free cloths for cleaning.
Environmental pollution due to incorrect disposal
Careless disposal of the Hägglunds motor and its ttings, the hydraulic uid and
the packaging material could lead to pollution of the environment.
▶ Dispose of the Hägglunds motor, hydraulic uid and packaging in accordance
with the national regulations in your country.
▶ Dispose of the hydraulic uid in accordance with the applicable safety data
sheet for the hydraulic uid.
Escaping or spilling hydraulic uid
Environmental pollution and contamination of the ground water.
▶ Always place a drip tray under the Hägglunds motor when lling and draining
the hydraulic uid.
▶ Use an oil binding agent if hydraulic uid is spilled.
▶ Observe the information in the safety data sheet for the hydraulic uid and the
specications provided by the system manufacturer.
The warranty applies only to the delivered conguration.
The entitlement to warranty cover will be rendered void if the product is incorrectly
installed, commissioned or operated, or if it is used or handled improperly.