RE 15300-WA, Version 06.2021, Bosch Rexroth AB
Installation 23/72
7.3 Required tools
7.3.1 Assembly tool for coupling adapter
An assembly tool can be used for easier and faster mounting of the coupling
adapter to the driven shaft. The assembly tool is passed through the coupling
adapter and screwed into the threaded hole in the driven shaft. The coupling
adapter is pulled onto the shaft by turning the nut on the assembly tool.
Material ID Assembly tool for coupling adapter:
Material ID R939003803
For installations when the threaded hole on the customer shaft is M30, a M30 to
M20 adapter, material ID R939067679, must be used on the customer shaft.
4
Fig. 14: Mounting coupling adapter with assembly tool
Driven shaft Assembly tool
2 3
DD00058172
DD00058276
71
6
Coupling adapter:
1 Lifting eye
2 Dismounting tool
3 Screws
4 Adapter shaft
5 Shrink disc
Assembly tool for coupling adapter:
6 Nut
7 Carriage beam
8 Adapter M30 to M20 (included in
delivery)
8
5
To Next Page
Loading...
