Bosch Rexroth Hagglunds CBm - Tool for Spline Alignment

24/72 Installation
Bosch Rexroth AB, RE 15300-WA, Version 06.2021
1
2
7.3.2 Tool for spline alignment
Before the motor is mounted on the driven shaft, the spline teeth in the cylinder
block must be aligned against the spline teeth gap of the driven shaft. The spline
align tool is used to rotate the cylinder block to the correct position.
The tool is also recommended to be used when monting the mounting kit as a
support for the socket and torque multiplier.
Material ID Spline alignment tool:
Material ID R939061395
1 Spline align tool
2 Bar (Not included)
3 Assembly tool R939003866 (not included)
Fig. 15: Spline align tool
DD00077430
3