20/72 Transport and storage
Bosch Rexroth AB, RE 15300-WA, Version 06.2021
Fig. 13: Filling the motor with oil
6.2.2 Storing for extended periods or in uncontrolled environment
NOTICE
Insufcient cleanliness!
Risk of damage to equipment.
▶ Take extreme care to ensure that no contamination enters inside the motor.
If the motor is stored for more than 3 months in uncontrolled environment or more
than 12 months in controlled environment, it must be lled full with oil according
to below:
1. Place the motor as shown in Fig. 12, alt.A) Standing with shaft horizontal.
2. Fill the motor full with ltered oil containing a mixture of 0,4% FUCHS
ANTICORIT VCI UNI O 40, or similar corrosion inhibitor compatible with the
selected uid in the following order: D1, A1 and C1.
NOTE! See Table 6. for oil volume
3. Fit the plug to D1.
4. Seal connections A1 and C1 with the cover plates tted to the connection
surfaces at delivery. Check that the O-rings or rubber seals are in position in
the cover plates.
5. Position the motor as shown in Fig. 12, alt. A) Standing with shaft horizontal or
B) Standing with shaft vertical.
A1
C1
D1Cover plate
DD00058244
Table 6: Motor case oil volume
Motor size Motor case oil volume including channels
Litre US gallon
CBm 2000 75 19.8
CBm 3000 91 24.0
CBm 4000 107 28.2
CBm 5000 123 32.4
CBm 6000 138 36.4
To Next Page
Loading...
