ECODRIVE DKC02.1 Drive Controller Safety instructions for electrical drives 2-7
DOK-ECODRV-DKC02.1****-PRJ2-EN-P
2.6 Protection during handling and assembly
Handling or assembling drive components improperly may lead to per-
sonal injury.
CAUTION
Risk of injury due to improper handling!
Bodily injury may be caused by crushing, shearing, cut-
ting, and pounding forces.
⇒
Observe general construction and safety regulations
when working on electrical installations.
⇒
Use suitable assembly and transport equipment.
⇒
Take precautions to prevent pinching and crushing.
⇒
Use only suitable tools. Use special tools as pre-
scribed.
⇒
Employ lifting devices and tools according to the
manufacturers’ instructions.
⇒
If necessary, use suitable protective equipment (for
example goggles, safety shoes, protective gloves).
⇒
Do not stand under suspended loads.
⇒
Remove any leaking liquids on the floor immediately
to prevent slipping.
2.7 Safe battery usage
Batteries consist of reactive chemicals contained in a solid case. Im-
proper use can therefore lead to injuries or equipment damage.
CAUTION
Risk of injury due to improper handling!
⇒
Do not attempt to reactivate empty batteries by heat-
ing them or by any other means (danger of explosion
or corrosion).
⇒
Do not recharge batteries because they may leak or
explode.
⇒
Do not dispose of batteries by throwing them into a
fire.
⇒
Do not attempt to disassemble batteries.
⇒
Do not damage the electrical components installed in
the equipment.
Note: Environmental protection and disposal! The batteries con-
tained in the product are considered hazardous material for
land, sea, and air transport according to the legal regulations
(danger of explosion). Dispose used batteries separately from
other waste. Observe the national regulations in the country of
installation.
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
To Next Page
Loading...
