Bosch Rexroth Nexo - Page 186

186/263 Bosch Rexroth AG | Tightening Technology 3 608 870 A47
Nexo cordless Wi-Fi nutrunner | 3 608 870 A47/2017-
Options
ID code source
Operating mode settings
9.5.3.3 ID input
In this step, define the settings for the treatment of the ID input.
Table 9–12: Start step dialog
Element Description
Display time Indication how long the text will be displayed at the tool display.
Default setting: 1 second
Table 9–13: Start step dialog
Element Description
Selection of the ID code source Use this selection to set the source of the ID code for the results output.
–No ID code
Receipt of ID codes is ignored.
–Cycle counter
Default setting. The internal cycle counter numbers are used to create the
ID code.
– Open Protocol
The ID input made available via Open Protocol is used for generating the
ID code.
– Scanner
The valid barcode scanned last is used as ID code. The settings in the ID
input step(s) in mode or job are ignored for output of the ID code.
– Mulitple ID inputs
The ID input made available via the ID input step(s) in the job and/or mode
is used to generate the ID code.
– VW-XML (As of Nexo firmware version 1200)
The tag set by the VW-XML master PC <PI1> is used for generating the
ID code.
Delete ID code after start Display only for Open Protocol, Scanner and VW-XML:
Enable the check box to delete the ID code after start.
Table 9–14: Start step dialog
Element Description
Operating mode Use this selection to set the operating mode of the cordless Wi-Fi nutrunner:
Automatic (automatic mode) or Manual (manual mode)
Trigger
1
)
1. Configuration only possible in the manual operating mode.
Definition of the trigger conditions for the activation of the relevant operating
mode:
HMI, Open Protocol or PLC signal ManOp
Admit HMI program selection
1)
If the check box is activated, the program selection is released.
Default setting: activated
Admit HMI job selection
1)
If the check box is activated, the job selection is released.
Default setting: deactivated
Double clicking the ID input step or the respective icon opens the corresponding dialog for
entering the parameters.