3 608 870 A47 Tightening Technology | Bosch Rexroth AG 225/263
Nexo cordless Wi-Fi nutrunner | 3 608 870 A47/2017-05
9.8.6 Firmware
Settings Firmware
This menu item is used to display the firmware version and to start the firmware update.
When the firmware is updated, the NEXO-OS operating system is also updated.
As of version 1100 of the Nexo firmware, firmware updates can only be started with a capacity of the bat-
tery pack slide-in module of 25%.
After the new firmware version has been uploaded, the Nexo cordless Wi-Fi nutrunner is rebooted. There-
after, the new firmware is effective for the Nexo cordless Wi-Fi nutrunner.
Table 9–73: Firmware tab - firmware
Element Description
Refresh Click Update to load a new firmware version:
1. The Update nutrunner firmware dialog is opened.
2. Select the file (*.nxfw) for updating the firmware.
3. Click Update to start the update. Click Cancel to stop the update.
Firmware update was not carried out or canceled:
In this case restart the firmware update via the NEXO-OS. If the firmware update fails again, remove the
battery pack slide-in module of the nutrunner, wait until the nutrunner is de-energized and reinsert the bat-
tery pack. Start the nutrunner and wait until it is started up. Start the firmware update again via the NEXO-
OS.
Table 9–74: Firmware tab - previously installed firmware and configurations
Element Description
Previously installed firmware and
configurations
Click the Start button to load the previously installed firmware version and
the respective configurations.
To Next Page
Loading...
