3 608 870 A47 Tightening Technology | Bosch Rexroth AG 189/263
Nexo cordless Wi-Fi nutrunner | 3 608 870 A47/2017-05
9.6 Job
The job function is used to run process chains. The process chains (e.g. Scan barcode Enable
nutrunner three tightenings Block nutrunner) that are usually programmed using a PLC can be di-
rectly parameterized in the NEXO-OS operating system as so-called jobs.
Use this menu item to create and edit jobs. The jobs are parameterized similarly as tightening programs
with a job being a sequence of internal steps, see „Job steps“ (on page 190).
9.6.1 Structure of the Job tab
The header of the Job tab features the following buttons:
On its left, it shows icons to start various functions:
As of Nexo firmware version 1100, the job function is supported.
Table 9–19: Job tab
Element Description
Up to 256 jobs can be programmed.
Saves the current job.
Opens the Job information dialog. There you can save a comment on the current job,
max. 1000 characters.
Admissible characters are ASCII characters, numbers, spaces, hyphens, dashes and
underscore.
Deletes the current job. This displays a prompt asking whether the user really wishes
to remove the job.
Opens the Name dialog. There you can enter a new name for the job.
Table 9–20: Job - functions
Element Description
Adds an individual program.
Adds an ID input step. A maximum of five ID code steps can be added before an indi-
vidual program step.
Opens the dialog for editing the selected step.
Deletes the selected step.
Opens the Import dialog. Select the corresponding Job that is to be imported.
Opens a dialog for exporting the job.
Opens the Import all dialog to import all defined jobs.
Opens a dialog to export all jobs.
To Next Page
Loading...
