Tightening Technology | Bosch Rexroth AG 97/263
7.5.3 Messages
7.5.3.1 Available messages
As of Nexo firmware version 1100, the Open Protocol “Rexroth OP-Ford” is available.
Table 7–6: Available messages
MID Description Rexroth
OP
Rexroth
OP-Ford
MID 0001 Communication start x x
MID 0002 Acknowledgement of communication start x x
MID 0003 Communication stop x x
MID 0004 Command error x x
MID 0005 Command accepted x x
MID 0010 Tightening program numbers upload request x x
MID 0011 Tightening program numbers upload response x x
MID 0012 Tightening program data upload request x x
MID 0013 Tightening program data upload response x x
MID 0014 Tightening program subscription selected x x
MID 0015 Tightening program selected x x
MID 0016 Tightening program selected acknowledgement x x
MID 0017 Cancel tightening program selected subscription x x
MID 0018 Select tightening program x x
MID 0019 Make the presetting for OK/NOK counter x x
MID 0020 Reset the OK/NOK counter x x
MID 0021 Deactivate the OK/NOK counter x
MID 0030 OK counter upload request x
MID 0031 OK counter upload response x
MID 0040 Tool data upload request x x
MID 0041 Tool data upload x x
MID 0042 Deactivate tool x x
MID 0043 Activate tool x x
MID 0045
1
)
Define calibration value request x
MID 0050 ID code download request x x
MID 0150 ID code download request x
MID 0051 ID code upload subscription x x
MID 0052 Upload ID code x x
MID 0053 Upload ID code acknowledgement x x
MID 0054 Cancel upload ID code subscription x x
MID 0060 Last tightening results data subscription x x
MID 0061 Upload last tightening results data response x x
MID 0062 Last tightening results data acknowledgement x x
MID 0063 Cancel last tightening results data x x
MID 0064 Archived tightening results upload request x x
MID 0065 Archived tightening results response x x
MID 0070 Resulting system errors subscription x x
MID 0071 Upload resulting system errors x x
MID 0072 Upload system errors acknowledgement x x
MID 0073 Cancel system errors subscription x x
MID 0074 System error in tightening controller acknowledged x x
MID 0075 Acknowledgement System error in tightening controller acknowledged x x
MID 0076 System error status x x
MID 0077 System error status acknowledgement x x
MID 0078 Acknowledge system error in tightening controller x
MID 0080 Time on the tightening controller request x x
To Next Page
Loading...
