202/263 Bosch Rexroth AG | Tightening Technology 3 608 870 A47
Nexo cordless Wi-Fi nutrunner | 3 608 870 A47/2017-
9.7.4.3 End step
A tightening program ends with the end step.
The end step ends the tightening program and terminates each program column (A, B, etc.) in the run
sequence. The tightening program may have several end steps if it contains branches. The end step is
automatically inserted into the tightening program and cannot be deleted.
Table 9–46: Tightening step dialog - monitoring panel
Element Description
Torque, torque min. value, torque
max. value, angle, angle min. value,
angle max. value
These monitoring functions can also be selected.
Each of the monitoring limits can be marked as switching. If a limit is switch-
ing, the tightening process will be stopped with an NOK result when it ex-
ceeds or falls below its limit.
If it is not switching, the tightening process will be completed as usual, how-
ever, the result will be NOK.
Time This monitoring function is always active, i.e. a time span must be entered for
a timeout.
Double clicking the end step or the respective icon opens the corresponding dialog for en-
tering the name.
The entire tightening job can only be evaluated as OK, if it is terminated in column A. Otherwise, it will be
evaluated as NOK.
Table 9–47: End step dialog – settings panel
Element Description
Name End step name
To Next Page
Loading...
