RE 30162-B/04.11 | SYHNC100-SEK...X Bosch Rexroth AG 7/44
Safety instructions
Safety instructions2
General information on this chapter2.1
The SYHNC100-SEK controller assembly has been manufactured according
to the accepted rules of current technology. However, there is still the risk of
injury and damage to property if you do not observe this chapter and the safety
instructions in this documentation.
Read these instructions completely and thoroughly before working with the
f
product.
Keep this documentation in a location where it is accessible to all users at all
f
times.
Always include the required documentation when you pass the SYHNC100-
f
SEK...3X on to third parties.
Only operate the SYHNC100-SEK...3X in a technically immaculate condition
f
and as intended, in a safety- and risk-conscious manner, considering these
instructions.
In case of failures impairing the safety and modifications to the operating
f
behavior, shut down the SYHNC100-SEK...3X immediately and report the
failures to the responsible personnel.
Intended use2.2
The SYHNC100-SEK...3X is an electric assembly.
You may use the product as follows:
The SYHNC100-SEK...3X is intended exclusively for integration into a machine or
system or to be assembled with other components to form a machine or system.
The product may be commissioned only if it is integrated in the machine/system
for which it is designed. Observe the operating conditions and performance limits
specified in the technical data.
The SYHNC100-SEK...3X is used for the closed-loop control of speed and
torque and for the open-loop control of the torque of up to four mechanically
coupled secondary controlled drives. When using the unit, you moreover
need superordinate control logics with corresponding I/O components that in
connection with the SYHNC100-SEK...3X are responsible for the holistic control
of the machine's motion sequence and also its monitoring as regards safety.
The SYHNC100-SEK...3X must not be used in explosive environments.
The SYHNC100-SEK...3X is designed for professional and not for private use.
Intended use includes having read and understood this documentation, especially
the chapter 2 “Safety instructions”.
Improper use2.3
Any use deviating from the intended use is not intended and thus not admissible.
The installation or use of inappropriate products in safety-relevant applications
could result in unintended operating conditions when being used which in turn
could cause personal injuries and/or damage to property. Therefore please only
use a product for safety-relevant applications if this use is expressly specified and
permitted in the documentation of the product. For example in explosion-protected
areas or in safety-related control components (functional safety).
To Next Page
Loading...
